Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294918 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1448  Yaw Rate Sensor Output Value  


DESCRIPTION

The yaw rate and acceleration sensor is built into the airbag sensor assembly.

The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication.

The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1448 Yaw Rate Sensor Output Value When the vehicle speed is 20 km/h (12 mph) or more, an invalid data signal is received from the yaw rate sensor for 120 seconds or more. Yaw rate sensor (Airbag sensor assembly)

PROCEDURE

1.CHECK DTC

b.

Start and idle the engine.


c.

Drive the vehicle at a speed of 20 km/h (12 mph) or more for at least 120 seconds, and then stop the engine.


d.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
DTC C1448 is output A
DTC C1448 is not output B




A

B