Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297207 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of blind spot monitor sensor Blind Spot Monitor Beam Axis Adjustment DTCs are output (Click here)

PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 88172 2.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
E357011

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor LH.

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.



Hide 88162 3.REMOVE BLIND SPOT MONITOR SENSOR RH

a.
E357012

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor RH.

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.



Hide 88171 4.REMOVE BLIND SPOT MONITOR BRACKET LH

a.
E357013

Remove the 3 nuts and blind spot monitor bracket LH.


Hide 88161 5.REMOVE BLIND SPOT MONITOR BRACKET RH

a.
E357014

Remove the 3 nuts and blind spot monitor bracket RH.