Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297207 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Avoid any impact to the blind spot monitor sensor.

·

Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



HINT:
·

The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.

·

The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector.

·

The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-5°) by using a jig, and that the sensor is 16 to 24° from the line parallel to the vehicle center line.



PROCEDURE

Hide 88171 1.INSTALL BLIND SPOT MONITOR BRACKET LH

a.

Install the blind spot monitor sensor bracket LH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88161 2.INSTALL BLIND SPOT MONITOR BRACKET RH

a.

Install the blind spot monitor sensor bracket RH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88172 3.INSTALL BLIND SPOT MONITOR SENSOR LH

a.

Connect the connector.


b.

Install the blind spot monitor LH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88162 4.INSTALL BLIND SPOT MONITOR SENSOR RH

a.

Connect the connector.


b.

Install the blind spot monitor RH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 5.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

Hide 6.INSTALL REAR BUMPER ASSEMBLY

Hide 7.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION