Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR CROSSING TRAFFIC ALERT BUZZER › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297208 REAR CROSSING TRAFFIC ALERT BUZZER A

PARK ASSIST / MONITORING  REAR CROSSING TRAFFIC ALERT BUZZER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor buzzer removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision System
Initialize back door lock Initialize back door lock (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 73900 1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)

Hide 55545 2.REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)

Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

Hide 89747F 4.REMOVE BLIND SPOT MONITOR BUZZER

a.
E357017

for LHD:

i.

Using a clip remover, disengage the clamp.


ii.

Disconnect the connector to remove the blind spot monitor buzzer.



b.
E357018

for RHD:

i.

Using a clip remover, disengage the clamp.


ii.

Disconnect the connector to remove the blind spot monitor buzzer.