Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
86160B
1.INSTALL REAR SPEAKER ASSEMBLY
Engage the claw and guide to temporarily install the rear speaker assembly.
Using an air riveter or a hand riveter, install the rear speaker assembly with 3 new rivets order show in the illustration.
| *a | Incorrect | *b | Correct |
| *c | Riveter | *d | Mandrel |
Do not touch the speaker cone.
Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
Confirm that the rivets are seated properly against the speaker.
Do not tilt the riveter when installing the speaker with the rivets.
Do not leave any space between the rivet heads and speaker.
Do not leave any space between the speaker and door. Firmly hold the speaker and door together while installing the rivets.
If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.
Connect the connector.
67604
2.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
67498
3.INSTALL REAR DOOR REAR FRAME BRACKET
74272A
4.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
69284D
5.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG