Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM › 2016.10–2019.09
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0298220 DYNAMIC TORQUE CONTROL AWD SYSTEM C

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  U0073/86  Control Module Communication Bus OFF  U0100/85  Lost Communication with ECM / PCM "A"  U0126/84  Lost Communication with Steering Angle Sensor Module  U0129/83  Lost Communication with Brake System Control Module  


DESCRIPTION

·

The 4WD ECU assembly inputs the signals sent from the ECM and skid control ECU (brake actuator assembly), and steering sensor via the CAN communication system.

·

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0073/86 Control Module Communication Bus OFF
1.

When the following continues for 5 seconds or more:

-

Signals from the 4WD ECU assembly are not received.


2.

When the following occurs 10 times consecutively:

-

A communication malfunction (bus off) occurs one or more times within 0.1 seconds.



·

CAN communication system

·

4WD ECU assembly


U0100/85 Lost Communication with ECM / PCM "A"
1.

When both of the following continue for 2 seconds or more:

-

The voltage of the IG1 terminal is 10 V or more.

-

At a vehicle speed of 60 km/h (38 mph) or more, communication with the ECM cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

ECM


U0126/84 Lost Communication with Steering Angle Sensor Module
1.

When both of the following continue for 1 second or more:

-

The voltage of the IG1 terminal is 10 V or more.

-

Communication with the steering sensor cannot be performed.


2.

When all of the following occur 10 times consecutively:

-

The voltage of the IG1 terminal is 10 V or more.

-

The condition that communication with the steering sensor cannot be performed occurs once within 5 seconds.

-

Occurs 10 times or more within 60 seconds.



·

CAN communication system

·

4WD ECU assembly

·

Steering sensor


U0129/83 Lost Communication with Brake System Control Module
1.

When the following continues for 3 seconds or more:

-

The voltage of the IG1 terminal is 10 V or more.

-

Communication with the skid control ECU (brake actuator assembly) cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

Skid control ECU (Brake actuator assembly)



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Click hereDrivetrain>GF1A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE CONTROL AWD SYSTEM>DTC CHECK / CLEAR

Chassis > Four Wheel Drive > Trouble Codes
50001 118

b.

Record the output DTCs (dynamic torque control AWD system ).

HINT:

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



Result:
Proceed to
NEXT



NEXT

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)