Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298358 REAR VIEW MONITOR SYSTEM Y

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the rear view monitor system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.

HINT:

The rear view monitor display may be temporarily distorted due to radio waves around the vehicle.

Problem Symptom Cause

*: DTCs output as "Hist" will not be output again after DTCs are cleared.

Both of the following conditions are met:
·

The problem symptom indicates a rear view monitor display malfunction and the problem symptom cannot be reproduced.

·

DTC C1622 is output as "Hist" only.*


The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver.



Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.



Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC*
4.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212

b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR VIEW MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
NOTICE:

The radio and display receiver assembly may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

System Proceed to
Audio and Visual System (Click here)
Navigation System (Click here)



Result:
Result Proceed to
No DTCs are output A
DTCs are output (w/o Navigation System) B
DTCs are output (w/ Navigation System) C



A

5.CHECK CAN COMMUNICATION SYSTEM*

B

C

5.CHECK CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN DTCs are not output A
CAN DTCs are output B



A

6.PROBLEM SYMPTOMS CONFIRMATION

B

6.PROBLEM SYMPTOMS CONFIRMATION
Result:
Result Proceed to
Symptom does not occur A
Symptom occurs B



A

7.SYMPTOMS SIMULATION

B

8.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM
7.SYMPTOMS SIMULATION
Result:
Proceed to
NEXT



NEXT

8.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM
8.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM

b.

Result:
Result Proceed to
Symptom does not appear A
Symptom appears (w/o Navigation System) B
Symptom appears (w/ Navigation System) C



A

9.PROBLEM SYMPTOMS TABLE

B

C

9.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

10.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

10.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

Result:
Proceed to
NEXT



NEXT

11.ADJUST, REPAIR OR REPLACE
11.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

12.CONFIRMATION TEST
12.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END