Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR GLASS › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060314 WINDOW / GLASS _0298550 BACK DOOR GLASS A

WINDOW / GLASS  BACK DOOR GLASS  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 76871 1.REMOVE REAR SPOILER

Hide 85110R 2.REMOVE REAR WIPER MOTOR ASSEMBLY (w/ Rear Wiper)

Hide 85110R 3.REMOVE REAR LIGHT ASSEMBLY (for Bulb Type)

Hide 85110R 4.REMOVE REAR LIGHT ASSEMBLY (for LED Type)

Hide 86300C 5.DISCONNECT NO. 2 AMPLIFIER ANTENNA ASSEMBLY (w/ Woofer)

a.
B454747

Disconnect the connector.


Hide 82184 6.DISCONNECT NO. 1 BACK DOOR WIRE

a.
B454748

Disconnect the 2 connectors from the back door glass.


b.

w/ Glass Breakage Sensor:

i.
B454746

Disconnect the connector from the glass breakage sensor.



Hide 68131 7.REMOVE BACK DOOR GLASS

a.
B454724C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape to the area around the installation position of the back door glass on the back door panel to prevent it from being scratched.


b.
B454725C01
1.479,0.875 1.479,0.375 1.479,0.375 1.646,0.375 true 1.49,0.667 1.656,0.667 true 1.396,0.896 1.625,1.063 0.229,0.167 10 true *a
*a Matchmark


Place matchmarks on the back door glass and back door panel at the locations indicated in the illustration.

HINT:

Matchmarks are not necessary if the back door glass is not going to be reused.



c.
B454726C01
0.802,0.656 0.375,0.365 true 3,0.406 2.604,0.656 true 1.573,1.875 1.115,2.063 true 3.021,0.302 3.333,0.458 0.313,0.156 10 false *1 0.208,0.26 0.521,0.417 0.313,0.156 10 false *2 0.917,1.969 1.135,2.156 0.219,0.188 10 true *a
*1 No. 1 Back Window Glass Spacer
*2 No. 2 Back Window Glass Spacer
*a Piano Wire


Pass a piano wire between the back door panel and back door glass from the interior.


d.

Tie both wire ends to wooden blocks or similar objects that can serve as handles.


e.

Cut the adhesive by pulling the piano wire around the back door glass.

NOTICE:
·

When separating the back door glass, take care not to damage the paint or interior and exterior ornaments.

·

When cutting the adhesive, take care not to damage the connectors on the back door glass.

·

Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.




f.
B454727

Using suction cups, disengage the No. 1 back window glass spacer and No. 2 back window glass spacer and remove the back door glass.

NOTICE:
·

To prevent the back door glass from falling when performing this operation, be sure to hold the back door glass using suction cups.

·

Be careful not to drop the back door glass.

·

Leave as much adhesive on the back door panel as possible when removing the back door glass.




Hide 8.REMOVE BACK WINDOW OUTSIDE MOULDING LH

a.

When reusing the back door glass:

i.
B454730C01
0.125,0.125 0.438,0.448 0.313,0.323 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the back window outside moulding LH.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back window outside moulding LH with a new one.





Hide 9.REMOVE BACK WINDOW OUTSIDE MOULDING RH

HINT:

Use the same procedure as for the LH side.


Hide 10.REMOVE NO. 2 BACK WINDOW GLASS SPACER

a.

When reusing the back door glass:

i.
B454732C01
0.146,0.146 0.448,0.469 0.302,0.323 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the No. 2 back window glass spacer.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the No. 2 back window glass spacer with a new one.





Hide 11.REMOVE NO. 1 BACK WINDOW GLASS SPACER

HINT:

Use the same procedure as for the No. 2 back window glass spacer.


Hide 75575D 12.REMOVE BACK WINDOW LOWER MOULDING

a.

When reusing the back door glass:

i.
B454728C01
0.125,0.094 0.5,0.333 0.375,0.24 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the back window lower moulding.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back window lower moulding with a new one.





Hide 13.REMOVE BACK DOOR GLASS SPACER (for Upper Side)

a.

When reusing the back door glass:

i.
B454733C01
0.146,0.083 0.469,0.438 0.323,0.354 10 false *a
*a Back Side of Back Door Glass


Using a scraper, remove the 2 back door glass spacers.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back door glass spacer with a new one.





Hide 14.REMOVE BACK DOOR GLASS SPACER (for Side)

a.
B454734C01
0.094,0.083 0.406,0.24 0.313,0.156 10 false *a
*a Back Side of Back Door Glass


When reusing the back door glass:

i.

Using a scraper, remove the 4 back door glass spacers.

NOTICE:
·

Be careful not to damage the back door glass.

·

Be sure to replace the back door glass spacer with a new one.