Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Entry Function)
RM32H0E _58 Vehicle Interior _060784 THEFT DETERRENT / KEYLESS ENTRY _0299013 ENTRY AND START SYSTEM(for Entry Function) J

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Entry Function)  Back Door Entry Lock Function does not Operate  


DESCRIPTION

If the entry lock function does not operate for the back door only, but the entry unlock function operates, the request code is being transmitted properly from the back door. In this case, there may be a problem related to the lock switch (connection between the back door opener switch assembly and certification ECU (smart key ECU assembly)).

WIRING DIAGRAM

B423531E29
0.635,2.323 3.24,2.521 2.604,0.198 10 false Back Door Opener Switch Assembly 0.635,2.156 0.927,2.354 0.292,0.198 10 false S8 0.688,1.656 0.979,1.854 0.292,0.198 10 false 2 0.896,1.656 1.188,1.854 0.292,0.198 10 false E 2.208,1.646 2.5,1.844 0.292,0.198 10 false 1 2.198,1.115 2.49,1.313 0.292,0.198 10 false 3 2.021,1.646 2.313,1.844 0.292,0.198 10 false L 1.938,1.125 2.229,1.323 0.292,0.198 10 false UL 5.229,2.281 5.521,2.479 0.292,0.198 10 false E 5.24,1.625 5.938,1.844 0.698,0.219 10 false TSW6 5.208,1.094 5.906,1.313 0.698,0.219 10 false TSW5 4.906,2.271 5.198,2.469 0.292,0.198 10 false F1 4.844,1.208 5.208,1.417 0.365,0.208 10 false M67 4.927,1.01 5.219,1.208 0.292,0.198 10 false 26 4.927,1.531 5.219,1.729 0.292,0.198 10 false 27 4.917,2.073 5.208,2.271 0.292,0.198 10 false 18 5.604,0.438 5.896,0.635 0.292,0.198 10 false 5V 5.917,0.979 6.208,1.177 0.292,0.198 10 false 5V 5.125,2.854 6.667,3.271 1.542,0.417 10 false Certification ECU (Smart Key ECU Assembly) 4.854,1.74 5.188,1.938 0.333,0.198 10 false M67

CAUTION / NOTICE / HINT

NOTICE:
·

The entry and start system (for Entry Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING

·

When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

·

Check that there are no electrical key transmitter sub-assemblies in the vehicle.

·

Before replacing the certification ECU (smart key ECU assembly), refer to Precaution.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>PRECAUTION

·

After repair, confirm that no DTCs are output.



PROCEDURE

1.CHECK POWER DOOR LOCK CONTROL SYSTEM
a.

When the door control switch on the multiplex network master switch assembly is operated, check that the doors unlock and lock according to the switch operation.

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK

OK:

Door locks operate normally.



Result:
Proceed to
OK
NG



OK

2.INSPECT GTS (TR/B-DOOR LOCK SW)

NG

2.INSPECT GTS (TR/B-DOOR LOCK SW)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Entry&Start / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Entry&Start > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Tr/B-Door Lock SW Back door opener switch assembly (lock switch) ON or OFF ON: Back door opener switch assembly (lock switch) pressed
OFF: Back door opener switch assembly (lock switch) not pressed
·

Displays whether the back door opener switch assembly (lock switch) is on or off.

·

Use this Data List item to help determine if there is a switch malfunction when the back door lock function does not operate.


Body Electrical > Entry&Start > Data List
Tester Display
Tr/B-Door Lock SW
50003 125 16
HINT:

When checking the operation of the entry lock function several times, it can be operated up to 2 times consecutively. To operate the function 3 times or more consecutively, the doors need to be unlocked once. However, this is only for the entry lock function, other door lock operations, such as a wireless door lock operation can be performed consecutively.*

*: w/o Double Locking System



OK:

The GTS display changes correctly in response to the operation of the back door opener switch assembly.



Result:
Proceed to
OK
NG



OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NG

3.CHECK HARNESS AND CONNECTOR (BACK DOOR OPENER SWITCH ASSEMBLY - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
3.CHECK HARNESS AND CONNECTOR (BACK DOOR OPENER SWITCH ASSEMBLY - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
a.

Disconnect the M67 certification ECU (smart key ECU assembly) connector.


b.

Disconnect the S8 back door opener switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M67-27 (TSW6) - S8-1 (L) Always Below 1 Ω
S8-2 (E) - Body ground Always Below 1 Ω
M67-27 (TSW6) or S8-1 (L) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (LOCK SWITCH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (LOCK SWITCH)
a.

Remove the back door opener switch assembly.

Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR OPENER SWITCH>REMOVAL


b.

Inspect the back door opener switch assembly.

Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR OPENER SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NG

REPLACE BACK DOOR OPENER SWITCH ASSEMBLY