The theft warning siren assembly sounds if either of the following conditions is met:
The theft deterrent system is in the alarm sounding state.
The theft warning siren assembly is in the armed state when the power source, ground or communication line is open.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Inspect the fuses for circuits related to this system before performing the following procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Horn2 | Theft warning siren assembly | OFF/ON | - |
| Tester Display |
|---|
| Security Horn2 |
The theft warning siren assembly sounds and stops correctly when operated using the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Theft Warning Siren Assembly) |
Disconnect the theft warning siren assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M5-1 (+B) - Body ground | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M5-3 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F16 main body ECU (multiplex network body ECU) connector.
Disconnect the M5 theft warning siren assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F16-18 (SSCL) - M5-2 (CONT) | Always | Below 1 Ω |
| F16-18 (SSCL) or M5-2 (CONT) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the theft warning siren assembly with a new or known good one.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch ON, then off.
Set the theft deterrent system to "ARMED STATE".
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>SYSTEM DESCRIPTION
Check that the security indicator changes from illuminated to blinking.
Change the theft deterrent system to "ALARM SOUNDING STATE".
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>SYSTEM DESCRIPTION
Check that the theft warning siren assembly is sounding.
Theft warning siren assembly is sounding.
| Proceed to |
|---|
| OK |
| NG |
OK
NG