35330D
1.INSTALL OIL STRAINER ASSEMBLY
Perform this procedure only when replacement of the oil strainer assembly is necessary.
Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the oil strainer assembly.
Ensure that the O-ring is not twisted.
Install the oil strainer assembly to the transmission valve body assembly with the 3 bolts.
Make sure that the transmission wire is not pinched.
Be careful not to damage the O-ring.
Bolt (A): 16 mm (0.630 in.)
Bolt (B): 25 mm (0.984 in.)
35394D
2.INSTALL OIL CLEANER (CVT) MAGNET
| *1 | Oil Cleaner (CVT) Magnet |
Install the 3 oil cleaner (CVT) magnets to the transaxle oil (CVT) pan sub-assembly as shown in the illustration.
35106L
3.INSTALL TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY
Clean the transaxle oil (CVT) pan sub-assembly installation surface of the transaxle case.
Install the transaxle oil (CVT) pan sub-assembly and a new transaxle oil pan (CVT) gasket to the transaxle case with the 16 bolts.
Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly.
Using a 6 mm hexagon socket wrench, temporarily install the overflow plug and gasket to the transaxle oil (CVT) pan sub-assembly.
Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.
4.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
5.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK
51444A
6.INSTALL REAR ENGINE UNDER COVER LH
51441
7.INSTALL NO. 1 ENGINE UNDER COVER