Home › Drivetrain › K313 (MULTIDRIVE / CVT) › OIL COOLER
RM32H0E _52 Drivetrain _059624 K313 MULTIDRIVE / CVT _0299310 OIL COOLER A

K313 MULTIDRIVE / CVT  OIL COOLER  INSTALLATION  


PROCEDURE

Hide 33493C 1.INSTALL TRANSMISSION OIL COOLER

a.

Apply Toyota Genuine CVT fluid FE to 2 new O-rings, and install them to the transmission oil cooler.


b.

Install the transmission oil cooler to the continuously variable transaxle assembly with the 3 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:

Be careful not to damage the O-rings.



c.

Connect the No. 3 water by-pass hose and No. 4 water by-pass hose to the transmission oil cooler and slide the 2 clips to secure it.

NOTICE:

Fully insert the No. 3 water by-pass hose and No. 4 water by-pass hose to the 2nd rib on each oil cooler pipe.



Hide 3.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 5.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51444A 6.INSTALL REAR ENGINE UNDER COVER LH

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER