Home › Drivetrain › K313 (MULTIDRIVE / CVT) › REVOLUTION SENSOR
RM32H0E _52 Drivetrain _059624 K313 MULTIDRIVE / CVT _0299311 REVOLUTION SENSOR A

K313 MULTIDRIVE / CVT  REVOLUTION SENSOR  INSTALLATION  


PROCEDURE

Hide 89413M 1.INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring, and install it to the transmission revolution sensor (NOUT).

NOTICE:

Be careful not to damage or twist the O-ring.



b.

Install the transmission revolution sensor (NOUT) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NOUT) connector.


Hide 89413P 2.INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring, and install it to the transmission revolution sensor (NIN).

NOTICE:

Be careful not to damage or twist the O-ring.



b.

Install the transmission revolution sensor (NIN) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NIN) connector.


Hide 3.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51444A 4.INSPECT REAR ENGINE UNDER COVER LH

Hide 51441 5.INSTALL NO. 1 ENGINE UNDER COVER