Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 3ZR-FAE)
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0299737 VACUUM PUMP(for 3ZR-FAE) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 3ZR-FAE)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.

Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.


b.
C366916C01
1.854,0.198 2.167,0.198 false 2.24,0.073 2.552,0.271 0.313,0.198 10 false *a
*a Vacuum Gauge


Connect the hose of a vacuum gauge to the vacuum pump assembly.


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, measure the negative pressure of the vacuum pump assembly.

Standard Pressure:

Higher than 86.7 kPa (650 mmHg, 25.6 in.Hg)


If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP (for 3ZR-FAE)>INSPECTION

HINT:

Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.



e.

Remove the vacuum gauge from the vacuum pump assembly.


f.

Connect the union to connector tube hose to the vacuum pump assembly, and slide the clip to secure it.