A DTC is stored when the headlight ECU sub-assembly receives a light source malfunction signal from its respective headlight unit. The headlight ECU sub-assembly LH stores DTC B2439 or B243A.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2439 | Headlamp LH Circuit | headlight ECU sub-assembly LH light source malfunction | ·
Headlight unit assembly LH ·
Headlight ECU sub-assembly LH |
- |
| B243A | Headlamp RH Circuit | headlight ECU sub-assembly RH light source malfunction | ·
Headlight unit assembly RH ·
Headlight ECU sub-assembly RH |
- |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Operate the light control switch to turn on the low beam headlights.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTC B2439 and B243A are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (DTC B2439 is output) | B |
| NG (DTC B243A is output) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Replace the headlight unit assembly LH with a new or known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Operate the light control switch to turn on the low beam headlights.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTC B2439 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit assembly RH with a new or known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Headlight)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Operate the light control switch to turn on the low beam headlights.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTC B243A is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG