According to current from the ECM, the shift solenoid valve SLP controls primary pulley pressure in accordance with the requested gear ratio to perform gear ratio changes.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P28247F | Pressure Control Solenoid "J" Actuator Stuck Off | Either one of the following conditions is met (1 trip detection logic):
·
When the oil pressure sensor output is 0.4 MPa (4.1 kgf/cm2, 58 psi) or more and the target gear ratio is less than 1.0, the actual gear ratio is 2.0 or more for 2 seconds or more. ·
When the oil pressure sensor output is 0.4 MPa (4.1 kgf/cm2, 58 psi) or more and the target gear ratio is 2.0 or more, the actual gear ratio is less than 0.5 for 1.5 seconds or more. |
Continuously variable transaxle assembly (Shift solenoid valve SLP) | Comes on (Euro-OBD)
Does not come on (Except Euro-OBD) |
DTC stored | SAE Code:
P2820 |
| Vehicle Condition | |||
|---|---|---|---|
| Pattern 1 | Pattern 2 | ||
| Diagnostic Condition | The oil pressure sensor output value is 0.4 MPa (4.1 kgf/cm2, 58 psi) or more and the target gear ratio is less than 1.0. | ○ | - |
| The oil pressure sensor output value is 0.4 MPa (4.1 kgf/cm2, 58 psi) or more and the target gear ratio is 2.0 or more. | - | ○ | |
| Malfunction Condition | The actual gear ratio is 2.0 or more. | ○ | - |
| The actual gear ratio is less than 0.5. | - | ○ | |
| Duration | 2 seconds or more | 1.5 seconds or more | |
| Detection Logic | 1 trip detection logic | 1 trip detection logic | |
The ECM compares the actual gear ratio with the target gear ratio. When the actual gear ratio and target gear ratio are different, the ECM detects the malfunction, illuminates the MIL* and stores this DTC.
*: Euro-OBD
Perform initialization after replacing any parts related to the continuously variable transaxle system.
Click hereDrivetrain>K313F (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Check that no DTCs are stored after performing initialization.
Click hereDrivetrain>K313F (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Perform the D position test in Road Test.
Click hereDrivetrain>K313F (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>ROAD TEST
Check for DTCs again.
Click hereDrivetrain>K313F (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Read the DTCs using the GTS.
If any DTCs other than P28247F are output, perform troubleshooting for those DTCs first.
| Result | Proceed to |
|---|---|
| Only DTC P28247F is output | A |
| DTC P28247F and other DTCs are output | B |
A
B
Replace the continuously variable transaxle assembly.
When Not Using the Engine Support Bridge
When Using the Engine Support Bridge
| Proceed to |
|---|
| NEXT |
NEXT