Operating the iMT switch illuminates the iMT indicator light in the combination meter assembly. This displays the iMT system standby condition.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List
| Tester Display |
|---|
| iMT SW |
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| iMT SW | iMT switch status | ON or OFF | ·
ON: iMT switch being pressed and held ·
OFF: iMT switch not pressed |
- |
| Result | Proceed to |
|---|---|
| Data display is not within Normal Condition range | A |
| Data display is within Normal Condition range | B |
A
B
Click hereDrivetrain>EC69 (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>PROBLEM SYMPTOMS TABLE
| *a | Front view of wire harness connector
(to iMT Switch (Pattern Select Switch Assembly)) |
| *b | for TMMT Made |
| *c | for TMC Made |
Disconnect the iMT Switch (Pattern Select Switch Assembly) connector.
Measure the resistance according to the value(s) in the table below.
for TMMT Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F66-1 (GND) - Body ground | Always | Below 1 Ω |
for TMC Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F66-5 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F66 iMT switch (Pattern Select Switch Assembly) connector.
Disconnect the A38 ECM connector.
Measure the resistance according to the value(s) in the table below.
for TMMT Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F66-4 (IG) - A38-36 (MTMS) | Always | Below 1 Ω |
| F66-4 (IG) - Body ground | Always | 10 kΩ or higher |
for TMC Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F66-8 (IG) - A38-36 (MTMS) | Always | Below 1 Ω |
| F66-8 (IG) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the iMT switch (Pattern Select Switch Assembly).
Click hereDrivetrain>EC69 (MANUAL TRANSMISSION / TRANSAXLE)>INTELLIGENT MANUAL TRANSMISSION SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereDrivetrain>EC69 (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>PROBLEM SYMPTOMS TABLE
NG
Click hereDrivetrain>EC69 (MANUAL TRANSMISSION / TRANSAXLE)>INTELLIGENT MANUAL TRANSMISSION SWITCH>REMOVAL