The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the driving support buzzer (pre-collision city buzzer) removal/installation are shown below.
*1: When performing learning using the GTS.
*2: w/ Stop and start system
55670A
1.REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY
86120
2.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
55521C
3.REMOVE STEREO OPENING COVER WITH BRACKET (w/ Cover)
86140A
4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
55085
5.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
86652E
6.REMOVE DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)
Disengage the clamp.
Disconnect the connector to remove the driving support buzzer (pre-collision city buzzer).
If the driving support buzzer (pre-collision city buzzer) has been struck or dropped, replace it with a new one.