Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM32H0E _58 Vehicle Interior _060136 METER / GAUGE / DISPLAY _0294876 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Washer Fluid Level Warning Switch Circuit  


DESCRIPTION

The combination meter assembly and level warning switch assembly are connected via direct line. The combination meter assembly determines the washer fluid level and outputs warning messages according to the washer fluid level warning switch ON/OFF signal.

WIRING DIAGRAM

C369233E01
1.844,1.073 2,1.271 0.156,0.198 10 false 2 2.052,1.073 2.208,1.271 0.156,0.198 10 false E 2.969,1.083 3.125,1.281 0.156,0.198 10 false S 3.198,1.073 3.354,1.271 0.156,0.198 10 false 1 1.833,1.469 2.167,1.656 0.333,0.188 10 false A26 1.823,1.656 3.875,1.917 2.052,0.26 10 false Level Warning Switch Assembly 4.51,1.063 4.75,1.24 0.24,0.177 10 false 17 4.802,1.063 5.323,1.25 0.521,0.188 10 false WLVL 5.542,1.167 6.063,1.354 0.521,0.188 10 false I/F 4.792,2.313 5.313,2.5 0.521,0.188 10 false F4 4.781,2.51 6.708,2.75 1.927,0.24 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


PROCEDURE

1.INSPECT LEVEL WARNING SWITCH ASSEMBLY
a.

Remove the level warning switch assembly.

Click hereVehicle Exterior>WIPER / WASHER>WASHER LEVEL WARNING SWITCH>REMOVAL


b.

Inspect the level warning switch assembly.

Click hereVehicle Exterior>WIPER / WASHER>WASHER LEVEL WARNING SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)

NG

REPLACE LEVEL WARNING SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (LEVEL WARNING SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)
a.

Disconnect the F4 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A26-1 (S) - F4-17 (WLVL) Always Below 1 Ω
A26-1 (S) or F4-17 (WLVL) - Body ground Always 10 kΩ or higher
A26-2 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR