Home › General › MAINTENANCE › REAR BRAKE FLEXIBLE HOSE
RM32H0E _V1 General _059503 MAINTENANCE _0304826 REAR BRAKE FLEXIBLE HOSE A

MAINTENANCE  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

When reusing the rear flexible hoses, use the identification marks created during removal to install each rear flexible hose to its original position.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

NOTICE:

When installing the rear flexible hose, minimize twisting of the hose.


a.
C366027C02
1.5,0.406 1.813,0.604 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Install the rear flexible hose to the vehicle body with a new clip.

NOTICE:

Install the clip as far as it will go.



b.

Using a union nut wrench, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake tube.

·

Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




c.

Install the rear flexible hose to the flexible hose bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


d.

Install the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

Torque:
30.4 N*m (310 kgf*cm, 22 ft.*lbf)

NOTICE:

Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.