Home › Drivetrain › EC69 (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › 2018.05–2019.09
RM32H0E _52 Drivetrain _060311 EC69 MANUAL TRANSMISSION / TRANSAXLE _0300017 MANUAL TRANSAXLE SYSTEM C

EC69 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  U110387  Lost Communication with Stop and Start Control Module Missing Message  


DESCRIPTION

The ECM and engine stop and start ECU send and receive signals via CAN communication.

If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
U110387 Lost Communication with Stop and Start Control Module Missing Message When the Ignition switch has been turned ON, there is no communication between the ECM and engine stop and start ECU for 1.25 seconds or more (1 trip detection logic).
·

ECM

·

Engine stop and start ECU

·

CAN communication system


Does not come on DTC stored SAE Code:
U1103

CAUTION / NOTICE / HINT

HINT:

After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

·

Turn the ignition switch to ON on and wait for 2 seconds or more.



PROCEDURE

1.CLEAR DTC AND PERFORM ROAD TEST
a.

Clear the DTCs.

Powertrain > Transmission > Clear DTCs
50002 373
HINT:

Write down the currently output DTCs before clearing them.



b.

Start the engine and drive the vehicle at a low speed.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT (DTC U110387)
2.CHECK DTC OUTPUT (DTC U110387)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Transmission / Trouble Codes.

Powertrain > Transmission > Trouble Codes
50001 373

e.

Read the DTCs using the Techstream.


Result:
Result Proceed to
DTC U110387 is not output A
DTC U110387 is output B



A

B