The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
17410
1.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
89467C
2.REMOVE AIR FUEL RATIO SENSOR
for 2WD:
Disengage the wire harness clamp.
Remove the wire harness clamp bracket from the air fuel ratio sensor.
Using SST, remove the air fuel ratio sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).
If the air fuel ratio sensor has been struck or dropped, replace it.
for AWD:
Disengage the wire harness clamp.
Remove the wire harness clamp bracket from the air fuel ratio sensor.
Using SST, remove the air fuel ratio sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).
If the air fuel ratio sensor has been struck or dropped, replace it.