Home › Engine / Hybrid System › 8NR-FTS (INTAKE / EXHAUST) › EXHAUST PIPE (for AWD) › from 2018.05
RM32H0E _51 Engine / Hybrid System _059908 8NR-FTS INTAKE / EXHAUST _0293893 EXHAUST PIPE(for AWD) A

8NR-FTS INTAKE / EXHAUST  EXHAUST PIPE(for AWD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly, No. 2 center exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

·

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.

·

Touching high-temperature areas such as the engine and exhaust pipe could result in burns.



PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A392876

Remove the 2 bolts and disconnect the tail exhaust pipe assembly from the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst).


b.

Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst).


Hide 58166 2.REMOVE FRONT FLOOR COVER LH

a.
A395939C01
0,0 0,0 false
V100135

Bolt
V100136

Clip


Remove the 2 bolts, clip and disengage the 5 clamps to remove the front floor cover LH from the vehicle body.


Hide 58165B 3.REMOVE FRONT FLOOR COVER RH

HINT:

Perform the same procedure as for the front floor cover LH.


Hide 57533B 4.REMOVE FRONT FLOOR CENTER BRACE

a.
A392866

Remove the 8 bolts and 2 front floor center braces from the vehicle body.


Hide 17420K 5.REMOVE NO. 2 CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

a.
A392868

Remove the 2 bolts and disconnect the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst) from the front exhaust pipe assembly.


b.

Remove the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst) from the 4 exhaust pipe supports.


c.

Remove the exhaust pipe gasket from the front exhaust pipe assembly.


Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

for Rear Heated Oxygen Sensor:

i.
A396731

Disengage the clamp and disconnect the heated oxygen sensor connector.



b.

for Rear Air Fuel Ratio Sensor:

i.
A396731

Disengage the clamp and disconnect the air fuel ratio sensor connector.



c.
A392877

Remove the 2 nuts and disconnect the front exhaust pipe assembly from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).


d.

Remove the exhaust pipe gasket from the front exhaust pipe assembly.


Hide 89465 7.REMOVE HEATED OXYGEN SENSOR (for Rear Heated Oxygen Sensor)

Hide 89467C 8.REMOVE AIR FUEL RATIO SENSOR (for Rear Air Fuel Ratio Sensor)