Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 2) › from 2018.05
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0358466 AIR FUEL RATIO SENSOR(for Sensor 2) A

8NR-FTS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89467C 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor (sensor 2).

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

for 2WD:

i.
A396212C01
1.271,0.75 1.031,0.292 false 0.74,0.219 1.198,0.417 0.458,0.198 10 false SST 1.979,0.76 2.438,0.958 0.458,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)




ii.

Install the wire harness clamp bracket to the air fuel ratio sensor.


iii.

Engage the wire harness clamp.



b.

for AWD:

i.
A393633C01
1.375,0.469 1.094,0.271 false 2.396,0.281 2.708,0.479 0.313,0.198 10 false *a 0.76,0.188 1.073,0.385 0.313,0.198 10 false SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

39 N*m (398 kgf*cm, 29 ft.*lbf)




ii.

Install the wire harness clamp bracket to the air fuel ratio sensor.


iii.

Engage the wire harness clamp.



Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor (sensor 2).

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION