Home › Engine / Hybrid System › 8NR-FTS (INTAKE / EXHAUST) › EXHAUST PIPE (for AWD) › from 2018.05
RM32H0E _51 Engine / Hybrid System _059908 8NR-FTS INTAKE / EXHAUST _0293893 EXHAUST PIPE(for AWD) A

8NR-FTS INTAKE / EXHAUST  EXHAUST PIPE(for AWD)  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR (for Rear Heated Oxygen Sensor)

Hide 89467C 2.INSTALL AIR FUEL RATIO SENSOR (for Rear Air Fuel Ratio Sensor)

Hide 17410 3.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.

Install a new exhaust pipe gasket to the front exhaust pipe assembly.


b.

Install the front exhaust pipe assembly to the exhaust manifold converter sub-assembly (TWC: Front Catalyst) with 2 new nuts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

for Rear Heated Oxygen Sensor:

i.

Engage the clamp and connect the heated oxygen sensor connector.



d.

for Rear Air Fuel Ratio Sensor:

i.

Engage the clamp and connect the air fuel ratio sensor connector.



Hide 17420K 4.INSTALL NO. 2 CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

a.

Install a new exhaust pipe gasket from the front exhaust pipe assembly.


b.

Install the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst) from the 4 exhaust pipe supports.


c.

Install the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst) from the front exhaust pipe assembly with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17430 5.INSTALL TAIL EXHAUST PIPE ASSEMBLY

a.

Install a new exhaust pipe gasket to the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst).


b.

Connect the tail exhaust pipe assembly to the 3 exhaust pipe supports.


c.

Install the tail exhaust pipe assembly to the No. 2 center exhaust pipe assembly (TWC: Rear Catalyst) with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 57533B 6.INSTALL FRONT FLOOR CENTER BRACE

a.

Install the 2 front floor center braces to the vehicle body with the 8 bolts.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 7.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

a.

Perform Inspection After Repair after repairing an exhaust gas leak.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


Hide 58166 8.INSTALL FRONT FLOOR COVER LH

a.

Engage the 5 clamps to install the front floor cover LH to the vehicle body with the 2 bolts and clip.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 58165B 9.INSTALL FRONT FLOOR COVER RH

HINT:

Perform the same procedure as for the front floor cover LH.