| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13A6 | Open or Short Circuit in Motor | Parking brake actuator assembly open or short circuit is detected for 0.015 seconds or more. | ·
Parking brake actuator assembly ·
Wire harness or connector ·
Skid control ECU (brake actuator assembly) |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.
When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light blinks (red) when the ignition switch is first turned to ON.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / Electric Parking Brake / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Permission of RH Interlocking PKB Lock | Parking brake actuator assembly RH parking brake lock control permission status | OK or NG | - | - |
| Permission of LH Interlocking PKB Lock | Parking brake actuator assembly LH parking brake lock control permission status | OK or NG | - | - |
| Tester Display |
|---|
| Permission of RH Interlocking PKB Lock |
| Permission of LH Interlocking PKB Lock |
| Proceed to |
|---|
| NEXT |
NEXT
| *a | Front view of Parking Brake Wire Assembly | *b | (to wire harness connector) |
| *c | (to Parking Brake Actuator Assembly) | *d | for RH |
| *e | for LH | - | - |
Remove the parking brake wire assembly.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL
Check the parking brake wire assembly for damage.
No damage.
If damaged, there may be a short in the wire harness or a short to ground.
Inspect the parking brake wire assembly.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| dM3-2 (MRR-) - d2-1 (MRR-) | Always | Below 1 Ω |
| dM3-2 (MRR-) - d2-2 (MRR+) | Always | 10 kΩ or higher |
| dM3-2 (MRR-) or d2-1 (MRR-) - Body ground | Always | 10 kΩ or higher |
| dM3-1 (MRR+) - d2-2 (MRR+) | Always | Below 1 Ω |
| dM3-1 (MRR+) - d2-1 (MRR-) | Always | 10 kΩ or higher |
| dM3-1 (MRR+) or d2-2 (MRR+) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| eM3-2 (MRL-) - e2-1 (MRL-) | Always | Below 1 Ω |
| eM3-2 (MRL-) - e2-2 (MRL+) | Always | 10 kΩ or higher |
| eM3-2 (MRL-) or e2-1 (MRL-) - Body ground | Always | 10 kΩ or higher |
| eM3-1 (MRL+) - e2-2 (MRL+) | Always | Below 1 Ω |
| eM3-1 (MRL+) - e2-1 (MRL-) | Always | 10 kΩ or higher |
| eM3-1 (MRL+) or e2-2 (MRL+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Make sure the parking brake wire assembly is securely installed.
Disconnect the A42 skid control ECU (brake actuator assembly) connector.
Disconnect the d2*1 or e2*2 parking brake actuator assembly connector.
*1: for RH
*2: for LH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A42-2 (MRR+) - d2-2 (MRR+) | Always | Below 1 Ω |
| A42-3 (MRR-) - d2-1 (MRR-) | Always | Below 1 Ω |
| A42-2 (MRR+) or d2-2 (MRR+) - Body ground | Always | 10 kΩ or higher |
| A42-3 (MRR-) or d2-1 (MRR-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A42-13 (MRL+) - e2-2 (MRL+) | Always | Below 1 Ω |
| A42-12 (MRL-) - e2-1 (MRL-) | Always | Below 1 Ω |
| A42-13 (MRL+) or e2-2 (MRL+) - Body ground | Always | 10 kΩ or higher |
| A42-12 (MRL-) or e2-1 (MRL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the parking brake actuator assembly.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>INSPECTION
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C