Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR (for LED Type Turn Signal Light)
87961
2.REMOVE OUTER MIRROR (for Bulb Type Turn Signal Light)
87945
3.REMOVE OUTER MIRROR COVER (for LED Type Turn Signal Light)
87945
4.REMOVE OUTER MIRROR COVER (for Bulb Type Turn Signal Light)
81741B
5.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY (for LED Type Turn Signal Light)
81730B
6.REMOVE SIDE TURN SIGNAL LIGHT BULB (for Bulb Type Turn Signal Light)
81890D
7.REMOVE OUTER MIRROR LIGHT ASSEMBLY (for LED Type Turn Signal Light)
w/o Panoramic View Monitor System:
Click hereVehicle Exterior>LIGHTING (EXT)>DOOR MIRROR FOOT LIGHT>REMOVAL
81890D
8.REMOVE OUTER MIRROR LIGHT ASSEMBLY (for Bulb Type Turn Signal Light)
w/ Illumination:
Click hereVehicle Exterior>LIGHTING (EXT)>DOOR MIRROR FOOT LIGHT>REMOVAL
86790F
9.REMOVE SIDE TELEVISIN CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
8794A
10.REMOVE NO. 2 OUTER MIRROR COVER (for Bulb Type Turn Signal Light)
w/ Illumination:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to remove the No. 2 outer mirror cover as shown in the illustration.
11.REMOVE OUTER MIRROR RETRACTOR (for LED Type Turn Signal Light)
w/o Panoramic View Monitor System:
| *a | Cut here |
Cut the wire harness at the position as shown in the illustration.
| *a | Vinyl Tape |
Remove the vinyl tape.
Disengage the guides to remove the foam.
Disengage the guides to remove the seal.
If the seal is removed, replace it with a new one.
Remove the 4 screws and reinforcement.
Disconnect the connector.
Remove the 3 screws and unit drive assembly.
Disengage the claws and guides to remove the cover base B.
If the cover base B is removed, replace it with a new one.
Remove the 3 screws and cover base A.
If the screw is removed, replace it with a new one.
Disconnect the connector.
Disengage the guides.
Remove the wire harness as shown in the illustration.
If the wire harness is removed, replace it with a new one.
Remove the screw and retractor assembly from the visor body.