Home › Engine / Hybrid System › 8NR-FTS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for 2WD) › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _059909 8NR-FTS FUEL _0293904 FUEL SENDER GAUGE ASSEMBLY(for 2WD) A

8NR-FTS FUEL  FUEL SENDER GAUGE ASSEMBLY(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)


CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A374548

Disengage the 2 clamps to disconnect the wire harness.

NOTICE:

Do not damage the wire harness.



b.
A286571

Remove the harness protector from the wire harness.

NOTICE:

Do not damage the wire harness.



c.
A222038

Disconnect the fuel sender gauge assembly connector.


d.
A374551

Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.