Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297206 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U0233  Lost Communication with Blind Spot Monitor Master Module  


DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH (Master) judges that there is a communication problem with the blind spot monitor sensor RH (Slave).

DTC No. Detection Item DTC Detection Condition Trouble Area
U0233 Lost Communication with Blind Spot Monitor Master Module The blind spot monitor sensor (slave) cannot receive signals from the blind spot monitor sensor (master)
·

Blind spot monitor sensor LH (Master)

·

Blind spot monitor sensor RH (Slave)

·

Wire harness or connector



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.


HINT:
·

Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.

·

Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.



PROCEDURE

1.CHECK DTC OUTPUT
a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON.


c.

Clear the DTCs.

Body Electrical > Blind Spot Monitor Slave > Clear DTCs
50002 314

d.

Check for DTCs.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
DTC U0233 is output A
No DTCs are output B



A

2.REPLACE BLIND SPOT MONITOR SENSOR LH

B

2.REPLACE BLIND SPOT MONITOR SENSOR LH

NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Check for DTCs.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
DTC U0233 is output A
No DTCs are output B



A

B

END (BLIND SPOT MONITOR SENSOR LH WAS DEFECTIVE)