Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER (for Radio and Display Type) › 2019.09–2020.08
RM32H0E _56 Audio / Visual / Telematics _060227 AUDIO / VIDEO _0298049 RADIO RECEIVER(for Radio and Display Type) A

AUDIO / VIDEO  RADIO RECEIVER(for Radio and Display Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the radio and display receiver assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55470 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Hide 55406B 4.REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY

Hide 55670A 5.REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY

Hide 86140A 6.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET

a.
E362283

Remove the 4 screws.


b.
E429954C01
0,0 0,0 false
V113147

Remove in this Direction


Pull the radio and display receiver assembly with bracket toward the rear of the vehicle to disengage the claws and clips as shown in the illustration.


c.

Disconnect each connector and remove the radio and display receiver assembly with bracket.


Hide 55405B 7.REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY

a.
E395577

Disengage the claws to remove the instrument cluster finish center panel sub-assembly.


Hide 86211J 8.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.
E395922

Remove the 2 screws and No. 1 radio receiver bracket from the radio and display receiver assembly.


Hide 86212C 9.REMOVE NO. 2 RADIO RECEIVER BRACKET

a.
E395578

Remove the 2 screws and No. 2 radio receiver bracket from the radio and display receiver assembly.