The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power steering ECU assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.
1.REMOVE STEERING COLUMN ASSEMBLY
89650
2.REMOVE POWER STEERING ECU ASSEMBLY
Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.
If the power steering ECU assembly is subjected to an impact, replace it with a new one.
Do not pull the wire harness of the electric power steering column sub-assembly.
Do not allow any moisture to come into contact with the power steering ECU assembly.
Do not loosen any bolts not mentioned in the procedure.
Do not allow any foreign matter to contaminate the power steering ECU assembly.
Disconnect the connector.
for Type A:
Using a T40 "TORX" socket wrench, remove the 2 screws and power steering ECU assembly from the electric power steering column sub-assembly.
for Type B:
Remove the 2 bolts and power steering ECU assembly from the electric power steering column sub-assembly.
45254B
3.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER
Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.