Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU(for RHD) › 2019.09–2020.08
RM32H0E _55 Steering _059605 POWER ASSIST SYSTEMS _0292303 POWER STEERING ECU(for RHD) A

POWER ASSIST SYSTEMS  POWER STEERING ECU(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power steering ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration
·

Lane departure alert system (w/ Steering Control)

·

Toyota parking assist-sensor system*1

·

Parking support brake system*1

·

Simple intelligent parking assist system*1

·

Pre-collision system


(Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Power steering ECU assembly
·

Torque sensor zero point calibration

·

Assist map writing


·

DTCs are stored

·

EPS warning light illuminates


(Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 89650 2.REMOVE POWER STEERING ECU ASSEMBLY

NOTICE:
·

Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness of the electric power steering column sub-assembly.

·

Do not allow any moisture to come into contact with the power steering ECU assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU assembly.



a.
C366718

Disconnect the connector.


b.

for Type A:

i.
C365311

Using a T40 "TORX" socket wrench, remove the 2 screws and power steering ECU assembly from the electric power steering column sub-assembly.



c.
C345187

for Type B:

i.

Remove the 2 bolts and power steering ECU assembly from the electric power steering column sub-assembly.



Hide 45254B 3.REMOVE ELECTRIC POWER STEERING MOTOR SHAFT DAMPER

a.
C345188

Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.