Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Valeo Made Cold Area Specification Vehicles) › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295159 STARTER(for Valeo Made Cold Area Specification Vehicles) A

8NR-FTS STARTING  STARTER(for Valeo Made Cold Area Specification Vehicles)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the wire harness to the terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter assembly connector.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER