The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the clearance warning buzzer removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
73900
1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)
55545
2.REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)
55550
3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
89343D
4.REMOVE NO. 2 CLEARANCE WARNING BUZZER
for LHD:
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the No. 2 clearance warning buzzer.
for RHD:
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the No. 2 clearance warning buzzer.
82660B
5.SEPARATE RELAY BLOCK ASSEMBLY
89343C
6.REMOVE NO. 1 CLEARANCE WARNING BUZZER
Using a clip remover, disengage the clamp.
Disconnect the connector to remove the No. 1 clearance warning buzzer.