Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU › 2019.09–2020.08
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298102 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Parking support brake system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Replacement of the clearance warning ECU assembly
·

Measurement of ultrasonic sensor detection angle

·

Steering angle neutral point

·

Bumper type registration

·

Ultrasonic sensor detection angle registration


·

Simple intelligent parking assist system

·

Toyota parking assist-sensor system

·

Parking support brake system


(Click here)

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.


HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 55470 1.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Hide 67914 2.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 3.REMOVE COWL SIDE TRIM BOARD LH

Hide 55606 4.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55434B 5.REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL

Hide 55440D 6.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 55406B 7.REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY

Hide 86841 8.REMOVE NAVIGATION ECU WITH BRACKET (w/ Navigation System)

Hide 82660B 9.SEPARATE RELAY BLOCK ASSEMBLY

a.
E357043

Remove the 2 nuts to separate the relay block assembly.


Hide 89343C 10.REMOVE NO. 1 CLEARANCE WARNING BUZZER

Hide 89340A 11.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.
E426311

Disconnect the connector.


b.

Remove the 2 screws.


c.

Disengage the guides to remove the clearance warning ECU assembly.