CHECK DTC AND FREEZE FRAME DATA (USING GTS)
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC/EPB / Trouble Codes.
Check for DTCs.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
The electric parking brake system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the electric parking brake system are output, refer to Diagnostic Trouble Code Chart for the relevant system.
| System | Proceed to |
|---|---|
| Vehicle Stability Control System | ( )
|
Check the freeze frame data.
If DTCs are output, check the freeze frame data and read the vehicle status when the DTC was stored.
for Freeze Frame Data: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>FREEZE FRAME DATA
CLEAR DTC AND FREEZE FRAME DATA (USING GTS)
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC/EPB / Trouble Codes.
Clear the DTCs.
When DTCs are cleared, the freeze frame data will also be cleared.
CHECK DTC (USING SST CHECK WIRE)
Turn the ignition switch off.
| *1 | DLC3 |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Do not connect the wrong terminals, as this may damage electrical components.
Turn the ignition switch to ON, and read the DTCs from the number of blinks of the parking brake indicator light (red).
When normal, the light blinks at 0.25 second intervals.
If one code is detected:
The light repeats the same code after a pause of 4.5 seconds.
If multiple codes are detected:
The light outputs one code after another with a 2.5-second pause between each code.
When all codes have been output, there is a 4.5-second pause and then the light begins to output the codes again.
If more than 1 malfunction is detected at the same time, the lowest numbered code will be displayed first.
Check the details of the DTCs.
| Warning Light Display | GTS Display |
|---|---|
| 19 | C13B0 |
| 35 | C13B4 |
| 41 | C13A5 |
| 42 | C13A6 |
| 43 | C13A7 |
| 53 | U0100 |
| 64 | P0805 |
| 65 | C1207 |
| 71 | C13AA |
CLEAR DTC (USING SST CHECK WIRE)
Turn the ignition switch off.
| *1 | DLC3 |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Do not connect the wrong terminals, as this may damage electrical components.
Turn the ignition switch to ON.
Within 5 seconds, pull the electric parking brake switch assembly to the lock side 5 times.
If the electric parking brake switch (electric parking brake switch assembly) is pulled too quickly, the system may not respond. If the system does not respond, perform the operation again more slowly.
Check that a normal system code is output (the parking brake indicator light blinks (red) at 0.25 second intervals).
If the malfunction exists, the DTC cannot be cleared.