Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM › from 2019.09
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0298220 DYNAMIC TORQUE CONTROL AWD SYSTEM C

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  C1280  Engine Circuit Malfunction  


DESCRIPTION

If a malfunction in the ECM circuit occurs, the 4WD ECU assembly will output this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1280 Engine Circuit Malfunction When the following continues for 5 seconds or more:
·

Communication with engine control ECM is operating normally, but engine control system is malfunctioning.


·

Engine control system

·

4WD ECU assembly



CAUTION / NOTICE / HINT

HINT:

Check the condition of each related circuit connector before troubleshooting.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE


PROCEDURE

1.CHECK FOR DTC (ENGINE CONTROL SYSTEM)
a.

Check if the engine control system DTC is output.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
Engine control system DTC is not output A
Engine control system DTC is output B




A

B

GO TO ENGINE CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)