Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › 4WD CONTROL ECU › 2019.09–2020.08
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0292796 4WD CONTROL ECU A

GF1A TRANSFER / 4WD / AWD  4WD CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the 4WD ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

*2: When the 4WD ECU assembly is replaced with a new one, calibration is unnecessary.

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration
·

Lane departure alert system (w/ Steering Control)

·

Toyota parking assist-sensor system*1

·

Parking support brake system*1

·

Simple intelligent parking assist system*1

·

Pre-collision system


(Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
4WD ECU assembly (When replaced with a normal one from another vehicle)*2 Clear zero point calibration data Dynamic torque control AWD system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62551F 3.REMOVE REAR SEAT SIDE GARNISH

Hide 89630A 4.REMOVE 4WD ECU ASSEMBLY

C360112

a.

Disconnect the connector.


b.

Remove the bolt and 4WD ECU assembly.