Home › Suspension › REAR SUSPENSION › REAR UPPER ARM › from 2019.09
RM32H0E _53 Suspension _059601 REAR SUSPENSION _0292267 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: w/ Height Control Sensor

Rear wheel alignment adjustment
1.

Clear zero point calibration data.

2.

Perform yaw rate and acceleration sensor zero point calibration.


·

DTCs are stored

·

ABS warning light illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)
Removal/installation of rear height control sensor sub-assembly LH*1 Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Parking support brake system

·

Simple intelligent parking assist system


(Click here)
·

Parking assist ECU initialization

·

Adjust steering angle


Panoramic view monitor system (Click here)
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


·

for 8NR-FTS:

(Click here)

·

for 3ZR-FAE:

(Click here)



CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 51206A 1.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY (for 2WD)

Hide 51206A 2.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY (for AWD)

Hide 48790 3.REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH (for 2WD)

a.
C345084

Remove the bolt, nut and rear upper control arm assembly LH from the rear suspension member sub-assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



Hide 48790 4.REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH (for AWD)

a.
C345085

Remove the bolt, nut and rear upper control arm assembly LH from the rear suspension member sub-assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



Hide 48770A 5.REMOVE REAR UPPER CONTROL ARM ASSEMBLY RH (for 2WD)

HINT:

Perform the same procedure as for the LH side.


Hide 48770A 6.REMOVE REAR UPPER CONTROL ARM ASSEMBLY RH (for AWD)

HINT:

Perform the same procedure as for the LH side.