Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH › 2019.09–2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296122 HEADLIGHT DIMMER SWITCH A

LIGHTING (EXT)  HEADLIGHT DIMMER SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight dimmer switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Steering sensor Steering angle neutral point
·

Toyota parking assist-sensor system

·

Parking support brake system

·

Simple Intelligent Parking Assist System


(Click here)
Panoramic view monitor system (Click here)

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 84307 1.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 84650 2.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Hide 84140 3.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

a.
E351163C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Disengage the claws to remove the headlight dimmer switch assembly as shown in the illustration.