Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ECU › 2019.09–2020.08
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296125 HEADLIGHT ECU A

LIGHTING (EXT)  HEADLIGHT ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight ECU sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
Headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

NOTICE:

If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89907 2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E420095

Remove the 3 screws.


b.
E420096

Disconnect the connector cover from the headlight ECU sub-assembly.


c.

for TMMT Made:

i.
E420097

Disconnect the 2 connectors to remove the headlight ECU sub-assembly.

NOTICE:

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.




d.

for TMC Made:

i.
E426160

Disconnect the connector to remove the headlight ECU sub-assembly.

NOTICE:

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.




Hide 81134 3.REMOVE HEADLIGHT GASKET

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E420098

Remove the headlight gasket.