Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2019.09
RM32H0E _52 Drivetrain _059517 AXLE AND DIFFERENTIAL _0291569 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42312B 2.REMOVE REAR AXLE SHAFT NUT (for AWD)

a.
C345047N01
2.438,1.313 2.51,1.156 2.51,1.156 2.74,1.156 false 2.802,1.104 3.26,1.302 0.458,0.198 10 false SST

Using SST and a hammer, release the staked part of the rear axle shaft nut.

SST
09930-00010  

NOTICE:

Loosen the staked part of the rear axle shaft nut completely, otherwise the threads of the rear drive shaft assembly may be damaged.



b.

While applying the brakes, remove the rear axle shaft nut.


Hide 3.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 4.REMOVE REAR DISC

Hide 5.DISCONNECT SKID CONTROL SENSOR WIRE (for 2WD)

a.
C365332

Using a screwdriver with its tip wrapped in protective tape, disconnect the skid control sensor connector from the rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the rear axle hub and bearing assembly and connector cover.



Hide 6.DISCONNECT SKID CONTROL SENSOR WIRE (for AWD)

a.
C365333

Using a screwdriver with its tip wrapped in protective tape, disconnect the skid control sensor connector from the rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the rear axle hub and bearing assembly and connector cover.



Hide 42450B 7.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD)

a.
C345046

Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.


Hide 42450B 8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (for AWD)

a.
C345048C03
2.344,1.729 2.344,0.781 2.344,0.781 2.646,0.781 true 2.354,1.104 2.781,1.104 true 2.271,1.74 2.563,1.948 0.292,0.208 10 false *a
*a Matchmark


Put matchmarks on the rear drive shaft assembly and the rear axle hub and bearing assembly.


b.
C345049

Using a plastic hammer, separate the rear drive shaft assembly from the rear axle hub and bearing assembly.

NOTICE:
·

Do not damage the rear drive shaft outboard joint boot.

·

Do not push the rear axle hub and bearing assembly towards the outside of the vehicle any further than necessary.



HINT:

If it is difficult to separate the rear drive shaft assembly rear axle hub and bearing assembly, tap the end of the rear drive shaft assembly using a brass bar and a hammer.



c.
C345050

Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.