1.INSTALL FRONT BUMPER ASSEMBLY
Move the front bumper assembly into position.
w/ Toyota Safety Sense:
Connect the connector.
w/ Wire Harness:
Connect the connector.
w/ Headlight Cleaner System:
Connect the washer hose.
|
Install in this Direction |
Temporarily install the front bumper assembly with the engage claw as shown in the illustration.
Install the 3 bolts.
|
Install in this Direction |
Engage the claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the 6 screws.
| *a | Correct |
| *b | Incorrect |
Install the pin hold clip as shown in the illustration.
Insert the pin hold clip with the slot aligned vertically.
Do not rotate the clip after inserting it.
After installation, confirm that the slot is aligned vertically.
Use the same procedure for the RH side and LH side.
Remove the protective tape.
75602A
2.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
Install in this Direction |
Engage the clips and claws to install the front fender moulding sub-assembly LH as shown in the illustration.
Install the 3 screws.
Install the 2 clips.
Remove the protective tape.
75601A
3.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
53141F
4.INSTALL RADIATOR COVER
Engage the guides and claws to install the radiator cover as shown in the illustration.
Install the 4 clips.
Install the 2 hood bumper cushions.
5.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)
6.ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)
7.PERFORM CALIBRATION
Parking support brake system and Simple intelligent parking assist system:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION
Panoramic view monitor system:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION