This DTC is stored if the ECM receives a malfunction signal from the brake actuator assembly (skid control ECU).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P175009 | Brake ECU Malfunction | When the vehicle is being driven at 20 km/h (12 mph) or more, the ECM receives a malfunction signal from the skid control ECU (brake actuator assembly) for 9 seconds or more (1-trip detection logic). | Vehicle stability control system | Comes on | DTC stored | SAE Code:
P1750 |
After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Drive the vehicle at 20 km/h (12 mph) or more for 9 seconds or more.
Check for DTCs again.
Click hereDrivetrain>K313 (MULTIDRIVE / CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Check for brake control system DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B