Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 3ZR-FAE) › 2019.09–2020.08
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0299737 VACUUM PUMP(for 3ZR-FAE) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 3ZR-FAE)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the vacuum pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link

*1: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Simple intelligent parking assist system*1
Pre-collision system
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1.REMOVE BATTERY

Hide 29300 4.REMOVE VACUUM PUMP ASSEMBLY

a.
C366923

Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.


b.

Remove the 3 bolts and vacuum pump assembly from the engine assembly.


c.
C169250C01
1.333,1.646 1.333,1.823 1.333,1.823 1.188,1.823 false 1.844,1.104 1.844,0.208 1.844,0.208 2.083,0.208 true 1,1.771 1.583,2.021 0.583,0.25 10 *2 2.115,0.156 2.5,0.375 0.385,0.219 10 *1
*1 No. 2 O-ring
*2 No. 3 O-ring


Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.