The headlight ECU sub-assembly LH sends automatic headlight beam level control signals to each headlight swivel and leveling motor via LIN communication.
Each headlight ECU sub-assembly and headlight swivel and leveling motor communicate via LIN communication.
The headlight swivel and leveling motor operates according to power supplied and automatic headlight beam level control signals from its respective headlight ECU sub-assembly and sends its operating state to the headlight ECU sub-assembly.
The headlight ECU sub-assembly LH stores a DTC if it detects that a headlight swivel and leveling motor is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B2412 | Headlight Swivel Motor LH | Headlight swivel and leveling motor malfunction detected | Headlight unit assembly LH | AFS |
| B2413 | Headlight Swivel Motor RH | Headlight swivel and leveling motor malfunction detected | Headlight unit assembly RH | AFS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / AFS / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / AFS / Trouble Codes.
Check for DTCs.
DTC B2412 and B2413 are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (DTC B2412 is output) | B |
| NG (DTC B2413 is output) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C