The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the occupant detection sensor removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL
73230
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY
71073S
3.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
72494
4.REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
72537
5.REMOVE RECLINING HINGE OUTER COVER
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
72525A
6.REMOVE RECLINING ADJUSTER RELEASE HANDLE
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
71848A
7.REMOVE SEAT ADJUSTER COVER CAP (w/ Vertical Adjuster)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
71811D
8.REMOVE FRONT SEAT CUSHION SHIELD
71861
9.REMOVE FRONT SEAT INNER CUSHION SHIELD
10.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
71511S
12.REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
Using a screwdriver, disengage the claws to remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.
| *a | Screwdriver | - | - |