This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is on even when the ignition switch is ON.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2780 | Push Switch / Key Unlock Warning Switch Malfunction | The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip detection logic*). | ·
Wire harness or connector ·
Unlock warning switch assembly ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2780 | Key SW |
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2780 is not output.
| Result | Proceed to |
|---|---|
| B2780 is not output | A |
| B2780 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Remove the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL
Inspect the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F13 unlock warning switch assembly connector.
Disconnect the F22*1, F137*2 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F13-1 (UN+) - F22-3 (KSW)*1
F13-1 (UN+) - F137-5 (KSW)*2 |
Always | Below 1 Ω |
| F13-2 (UN-) - Body ground | Always | Below 1 Ω |
| F13-1 (UN+) - Body ground | Always | 10 kΩ or higher |
| F22-3 (KSW) - Body ground*1
F137-5 (KSW) - Body ground*2 |
Always | 10 kΩ or higher |
*1: for 16 Pin Type
*2: for 12 Pin Type
| Proceed to |
|---|
| OK |
| NG |
OK
NG