The headlight ECU sub-assembly LH stores this DTC if the sensor value received from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH; for example, the vehicle is not level or being jack up.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2452 | Height Control Sensor Data Out of Range When Initializing | Rear height control sensor sub-assembly LH value is out of range when initializing | ·
Vehicle condition when initializing ·
Rear height control sensor sub-assembly LH |
- |
If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Replacement of the rear height control sensor sub-assembly LH
Removal/installation of the rear height control sensor sub-assembly LH
Work that changes the vehicle height such as replacement of suspension components
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
DTC B2452 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check the installation condition of the rear height control sensor sub-assembly LH.
Rear height control sensor sub-assembly LH is installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG