Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2019.09
RM32H0E _58 Vehicle Interior _060136 METER / GAUGE / DISPLAY _0294876 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Meter Illumination is Always Dark  


DESCRIPTION

The combination meter assembly receives signals from this circuit to adjust the illumination of the combination meter assembly. The combination meter assembly sets the illumination level based on the user operation of the light control rheostat switch.

WIRING DIAGRAM

E341411E03
0.073,3.104 1.719,3.604 1.646,0.5 10 false Main Body ECU (Multiplex Network Body ECU) 2.948,3.188 4.844,3.385 1.896,0.198 10 false : CAN Communication Line 5.281,3.104 7.135,3.427 1.854,0.323 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



HINT:
·

The meter illumination dims when the taillights are turned on.

·

Setting the meter illumination level to maximum brightness cancels the above dimming of the meter illumination.

·

Setting the meter illumination level to minimum brightness turns off the meter illumination.

·

The automatic light control sensor sensitivity can be customized.




PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication DTCs are not output. A
CAN communication DTCs are output. B



A

2.CHECK FOR DTC

B

2.CHECK FOR DTC
a.

Check if lighting system DTCs are output.


Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Result Proceed to
DTC B1244 is not output. A
DTC B1244 is output. (for Single Beam Headlight) B
DTC B1244 is output. (for Triple Beam Headlight) C



A

3.REPLACE COMBINATION METER ASSEMBLY

B

C

3.REPLACE COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL

OK:

The operation of the combination meter assembly returns to normal.



Result:
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

END

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)